Color Melting - Unicorn Melt

These are the products you'll need
COLOR

SECTIONING

Section the hair into quadrants.

BALAYAGE

Starting in nape, using ½ inch sub-sections create a zig-zag parting, place hair on foil. Freehand Formula A feathering ½ inch from scalp through to the ends.Leave hair in-between next section and repeat this step through the entire head.

PROCESS UNTIL DESIRED LIGHTNESS IS ACHIEVED OR UP TO 50 MINUTES, RINSE THOROUGHLY. BLOW-DRY SECTION THE HAIR INTO QUADRANTS.

MELT

Starting in the nape, create a more exaggerated zig-zag parting than before. Melt together 2 formulas by applying Formula C then D.Mastery Point: Always apply your lightest color first melting into your darkest color.Next you will leave a section of hair in-between. Then you will alternate your formulas in your next section by applying Formula B and D.Visually alternate your placement of melting these formulas as you work up the head until complete.Apply Formula E to the hair remaining in-between all the foils.

PROCESS UP TO 20 MINUTES, RINSE THOROUGHLY

APPLY

BOND Ultim8 Step 2. Process for 10 minutes. Rinse thoroughly, cleanse & condition with Total Results So Long Damage Shampoo and Conditioner.




FORMULA A: 

1 scoop Light Master & 1 oz. 30 Volume MATRIX Cream Developer & BOND Ultim8 Step 1

FORMULA B:

1 tube Color Graphics Clear + 3 drops of Blue + 1 drop of Teal

FORMULA C:

1 tube Color Graphics Clear + 3 drops Yellow

FORMULA D:

1 tube Color Graphics Clear + 3 drops Magenta

FORMULA E:

1:1 Color Sync SPN & 10 Volume MATRIX Cream Developer & BOND Ultim8 Step 1

SHAPE

STEP ONE

Separate the hair into three sections. Create an ear to ear radial parting and then a center profile part from the front hairline to the radial parting. Isolate fringe. Comb the fringe forward and cut to establish the guideline for a face frame.

PERIMETER:

Establish a perimeter in the back section.

STEP 2

Slightly overdirect the front sections forward and connect the face frame guideline to the perimeter guideline.
Mastery Point: Slide Cut or cut with center of the shears to avoid removing the corners.

STEP 3

Overdirect the front sections to the top center of the crown and trim length to create a shallow layer.
Mastery Point: Cut front and back sections at a steep angle to maintain perimeter.
Overdirect the back section to the top center of the crown and trim length to create a shallow layer.

TEXTURIZE

Point Cut throughout crown area to create movement and texture.

STYLE

BLOW-DRY

Apply Style Link Volume Builder to damp hair and blow-dry with a round brush to create body. Begin to section hair by creating a center part. Next, separate the hair into three sections: two in the front and the one in the back is left loose.

SECTION

Create three low ponytails in the back section, the middle ponytail is created last and directed over the partings. Next, create a ponytail on each side of the head in the front section.

APPLY

Spray Style Link Texture Builder on the ponytails, pinch and pull above elastics to create loose volume.